1998 MG Mgf

Electrical wiring insecure and connectors likely to become disconnected (4.11 (a) (ii))

Horn not working (7.7 (a))

Nearside Rear Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Exhaust mounting defective Both clamps missing (6.1.2 (a))

Rear Tyres worn on inner edges slightly

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust mounting defective Tail pipes,both clamps missing (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Electrical wiring insecure and connectors likely to become disconnected Barrett negative connector (4.11 (a) (ii))

Exhaust mounting defective Tail pipes,both clamps missing (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Tyre over ten years old fitted to a rear axle of a bus (5.2.3 (m))

Rear Suspension arm pin or bush worn but not resulting in excessive movement front bush both sides (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Rear Upper Suspension arm has slight play in a pin/bush stub axle mounting bush worn (2.4.G.2)

Rear Brake pad(s) wearing thin inner pads worn low (3.5.1g)

Rear Exhaust has a minor leak of exhaust gases rear silencer outer casing corroded (7.1.2)

Rear silencer corroded

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Covers impede parts of the inspection.

Exhaust rear silencer outer skin corroding.

Headlamp lenses discolouring.

Nail in inner edge of offside rear tyre.

Nearside front tyre tread depth near limit on inner edge.

Front registration plate character(s) incorrectly spaced (6.3.4a)

Covers impede parts of the inspection.

Exhaust rear silencer outer skin corroding.

Headlamp lenses discolouring.

Nail in inner edge of offside rear tyre.

Nearside front tyre tread depth near limit on inner edge.

Nearside Inner Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front registration plate character(s) incorrectly spaced (6.3.4a)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front registration plate character(s) incorrectly spaced (6.3.4a)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Rear Registration plate lamp not working (1.1.5c)