2009 Abarth 500

rear axel corroded

Emissions not tested (8.2.1.2 (d))

Nearside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake lever has insufficient reserve travel handbrake lever coming up too high (1.1.2 (a))

Emissions not tested due to intake pipe problems as listed above (8.2.1.2 (d))

Exhaust emissions likely to be affected by an induction leak intake clips are loose and ineffective, also a hose is missing towards front of the engine compartment and towards the n/s (8.2.2.1 (b))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Front Headlamp aim projected beam image is obviously incorrect blurred and indistinct beam pattern (4.1.2 (c))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened all four brake discs are worn/scored/rusted (1.1.14 (a) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Tyre worn close to legal limit/worn on edge both o/s/r and n/s/r tyres are wearing on the inner edges (5.2.3 (e))

Rear reverse lamp is wrong colour

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Stop lamp not working (1.2.1b)

Nearside Front Lower Suspension arm rubber mounting deteriorated but not resulting in excessive movement inner rear (2.4.G.2)

Nearside Rear Nail in tyre ()

Rear Exhaust has a minor leak of exhaust gases box exc. corroded to outer skin (7.1.2)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Tyre has ply or cords exposed inner edge (4.1.D.1b)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure inner wall (4.1.D.1b)

Offside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Lower Suspension arm rubber mounting deteriorated but not resulting in excessive movement inner rear (2.4.G.2)

Nearside Rear Nail in tyre ()

Rear Exhaust has a minor leak of exhaust gases box exc. corroded to outer skin (7.1.2)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

rear exhaust box exc. corroded to outer skin only

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

rear exhaust box exc. corroded to outer skin only

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

exhaust reat box exc. corroded to outer skin

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

nearside front tyre has several cuts on inner edge of tyre but not deep enoigh to reach cords

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)