1993 Nissan Micra

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Exhaust emits clearly visible black smoke during acceleration (7.3.A.2c)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7) DANGEROUS

both outer sills old repairs and undersealed

both underbody floor sills corroded and freshly undersealed

front cross member corroded but out of perscibed area

n/s/f tyre has cuts in it

n/s/f tyre worn on outer edge

o/s/r tyre starting to crack and perish

slight binding to o/s and n/s front brakes

Front Brake pad(s) wearing thin (3.5.1g)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front brake disc slightly pitted (3.5.1h)

Spare tyre defective

slight rear service brake imbalance

Front Brake pad(s) wearing thin (3.5.1g)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front brake disc slightly pitted (3.5.1h)

Nearside Front Headlamp aim too high (1.8)

Offside Front Headlamp aim too high (1.8)

Spare tyre defective

slight rear service brake imbalance

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

rear brake application uneven (3.7.B.2)

Nearside rear brake recording little or no effort (3.7.B.5a) DANGEROUS

HEAVY corrosion and holes in front cross member not within prescribed areas

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

corrosion to both inner sills

front inner pads about half worn

light corrosion to nearside rear inner wheel arch around seat belt mount

offside rear tyre perished and cracked and tyre has a cut in tread not deep enough to reach cords

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Registration plate lamp not working (1.1.5c)

Offside Rear Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)