2004 BMW 645

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Oil leak engine ()

Offside Front Headlamp aim too far to the right (1.8)

Oil leak engine ()

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Fuel cap/sealing device sealing washer deteriorated (7.2.4c)

Headlamp excessively damaged so that the light output is severely reduced (1.7.5a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Engine covers fitted obscuring some components in the engine bay

Oil leak

Under-trays fitted obscuring some underside components

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

both front tyres wearing inner edges

Offside Rear fog lamp not working (1.3.2b)

both front tyres wearing inner edges

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

EML warning light on

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)