1993 Toyota MR2

Brake lever has insufficient reserve travel (1.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Vehicle structure inadequately repaired such that structural rigidity is significantly reduced (6.1.1 (d) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Vehicle structure inadequately repaired such that structural rigidity is significantly reduced (6.1.1 (d) (i))

Both rear sills corroding

Nearside Rear Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive becoming excessive (8.4.1 (a) (i))

Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

oil leak

osf tyre worn on inner edge (wheel alignment required)

Emissions not tested (7.3.A.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

oil leak

osf tyre worn on inner edge (wheel alignment required)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

o/s/f tyre wearing on inner edges

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

o/s/f tyre wearing on inner edges

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside front brake binding (3.7.B.1)

Offside front brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Front brake disc slightly pitted (3.5.1h)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)