1992 Rover 416

Brake pedal spongy (3.3.B.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside rear brake recording little or no effort (3.7.B.5a)

Parking brake lever has no reserve travel (3.1.6b)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Trailing arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Trailing arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Nearside Front Headlamp aim too low (1.8)

Offside Inner Ball joint has slight play (2.2.B.1f)

Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Offside Front Steering arm has relative movement at its fixings (2.2.B.1h)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Rear registration plate delaminated (6.3.1d)

Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Front Windscreen wiper not operating automatically when switched on (8.2.1b)

Nearside Front Seat belt flexible stalk deteriorated likely to lead to failure under load (5.2.4a)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Rear Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Front position lamp(s) not working (1.1.A.3b)

Offside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.5c)