1992 Rover Metro

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Side repeater not working (1.4.A.2c)

Rear Statutory seat belt missing (5.1.1)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

advise to improve rear brake performance

corrosion on body,and underbody in places

passanger rear door,not opening from outside

rear wiper split

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

body corroding

Nearside Inner Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Inner Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

body corroding

drivers door handle broken,door opens from outside

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

outer front indicator lenses missing

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

outer front indicator lenses missing

Emissions not tested (7.0)

Nearside Front Fluid suspension has no suspension movement (2.4.D.5)

Nearside Front Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Fluid suspension has no suspension movement (2.4.D.5)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

n/s/f floor holed and corroded outside prescribed area

o/s/f tyre wearing low on inside edge

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)