1993 Subaru Impreza

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Emissions not tested (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Brake performance not tested wheel rims distorted (decelerometer type test required) (1.2.1 (g))

Emissions not tested exhaust blow from front pipe (8.2.1.2 (d))

Nearside Front Headlamp aim too high and too far to the right. (4.1.2 (a))

Offside Rear Body component corroded and likely to cause injury quarter panel /wheel arch (6.2.1 (a) (i))

Offside Rear Road wheel badly distorted (5.2.2 (c) (i))

Offside Rear Road wheel badly distorted (5.2.2 (c) (i))

Steering column attachment defective excessive side to side movment (2.2.2 (d) (i))

Nearside Front Vehicle structure is deformed but structural rigidity is not significantly reduced crossmember and chassis leg (6.1.1 (a) (i))

Nearside Headlamp lens slightly defective lense blistering internally (4.1.1 (b) (i))

nearside and offside headlight wiring poorly secured

Brake performance not tested (3.7.A.1)

Braking system leaking metal brake pipe above fuel tank (3.6.A.1) DANGEROUS

Offside Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

o/s/f outer side light

o/s/f outer side light not working

rear light units very damp slight poor output

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear fog lamp not working (1.3.2b)

Offside Registration plate lamp not working (1.1.C.1d)

o/s/r light lens broken

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

o/s/r light lens broken

metal brake pipes above rear subframe not tested

o/s/r light lens cracked

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

metal brake pipes above rear subframe not tested

o/s/r light lens cracked

metal brake pipe above rear subframe not tested

o/s outer ball joint boot split

tail box exhaust rusty

Suspension joint offside lower dust cover split/missing