1993 Mazda MX-6

Nearside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust system not adequately supported (7.1.1)

Service brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Fuel pipe/s corroded

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Trailing arm has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Outer Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Outer Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp insecure (1.1.C.1c)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Registration plate lamp not working (1.1.5c)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

offside front tyre worn on edge

Nearside Front brake caliper has restricted free movement (3.5.1k)

Offside Headlamp not working on dipped beam (1.7.5a)