1992 Fiat Ducato Motorhome

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced jacking point to step (6.1.1 (c) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor support and chassis (6.2.2 (d) (i))

Offside Front Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch area (6.1.1 (c) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor support and chassis (6.2.2 (d) (i))

Nearside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced rear step support (6.1.1 (c) (i))

Nearside Inner Brake pipe corroded, covered in grease or other material Pipe Front To Rear (1.1.11 (c))

Rear Inner Brake pipe corroded, covered in grease or other material on axle (1.1.11 (c))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Brake pipe corroded, covered in grease or other material front to rear brake pipe has slight corrosion (1.1.11 (c))

Brake pipe corroded, covered in grease or other material front to rear brake pipe has slight corrosion (1.1.11 (c))

Nearside Front Upper Position lamp not working (4.2.1 (a) (ii))

Brake load sensing valve stiff (1.1.17 (c) (ii))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Coil spring corroded both nearside and offside (5.3.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength front mountain area (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength rear mountain area (5.3.6 (a) (i))

Front Coil spring corroded x2 (5.3.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outrigger by jacking point (6.2.2 (d) (i))

Rear Brake load sensing valve stiff (1.1.17 (c) (ii))

Front Coil spring corroded both (5.3.1 (b) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced spring hanger area (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material corroded recommend new (1.1.11 (c))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced outrigger (6.1.1 (c) (i))

Rear Brake load sensing valve stiff (1.1.17 (c) (ii))

Parking (secondary brake) on a single line braking system imbalanced across an axle Axle 1 (1.3.1 (b) (i))

Front Coil spring corroded both (5.3.1 (b) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced spring hanger area (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material corroded recommend new (1.1.11 (c))

Offside Front Drive shaft joint constant velocity boot severely deteriorated cracking (6.1.7 (g) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced outrigger (6.1.1 (c) (i))

Rear Brake load sensing valve stiff (1.1.17 (c) (ii))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear by spring hager corroded ok for test

Nearside Rear out rigger corroded

Offside Front Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Rear Brake load sensing valve linkage defective but function not impaired stiff (1.1.17 (a))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger corroded by jacking point (6.1.1 (c) (i))

Offside Front Upper Position lamp not working (4.2.1 (a))

Offside Rear Service brake excessively fluctuating (1.2.1 (e))

Windscreen washer not working (3.5 (a))

Offside Front Brake pad(s) less than 1.5 mm thick on metal (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced by outrigger byspring hanger (6.1.1 (c) (i))

Nearside Rear out rigger corroded

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced outrigger by jacking point (6.1.1 (c) (i))

Rear Brake load sensing valve stiff (1.1.17 (c) (i))

Brake load sensing valve seized (3.6.E.3)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Rear Mechanical brake component has restricted free movement (3.5.1k) DANGEROUS

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake load sensing valve seized (3.6.E.3)

nearside rear brake back plate damp

both rear top shock bushes starting to split

both rear tyres slight worn on inner edges

rear gearbox mount starting to split