1992 Mazda MX-5

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Shock absorbers has a slightly worn bush (5.3.2 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Registration plate does not conform to the specified requirements too small (0.1 (d))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Additional stop lamp not working

Nearside Front Upper ball joint split pin missing but does have a nylock nut fitted

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Upper ball joint split pin missing but does have a nylock nut fitted

Underside covered in underseal everywhere

Wipers smearing slightly

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Inner Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Central Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Stop lamp(s) not working both (4.3.1 (a) (ii))

Nearside Front Anti-roll bar linkage fractured (2.4.G.1)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Inner Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Outer Vehicle structure has slight corrosion (6.1.B.2)

Offside Outer Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear coil spring incomplete (2.4.C.1a)

Offside Rear coil spring incomplete (2.4.C.1a)

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Front Lower Front suspension locking device missing (2.5.A.4)

Centre Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)