1993 Rover Mini

Rear subframe heavily corroded

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear wheel cylinder leaking (3.6.A.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Brake cable has wires broken but is not significantly weakened (3.5.1b)

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Centre Rear Brake pipe excessively corroded (3.6.B.2c)

Driver's door cannot be opened from inside the vehicle (6.2.B.1b)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Steering column top bearing excessively worn (2.1.2c)

Brake cable has wires broken but is not significantly weakened (3.5.1b)

Centre Rear Brake pipe slightly corroded (3.6.B.2c)

Nail in nearside rear tyre

Direction indicators not working (1.4.A.2c)

Nearside Front All position lamps not working (1.1.A.3b)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Stop lamp not working (1.2.1b)

Offside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Headlamp aim too high (1.8)

Offside Rear All position lamps not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Centre Rear Brake pipe slightly corroded (3.6.B.2c)

Nail in nearside rear tyre

Nearside Front Vehicle structure has slight corrosion (6.1.B.2)

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Vehicle structure has slight corrosion (6.1.B.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Vehicle structure has slight corrosion (6.1.B.2)

Nearside Headlamp aim too low (1.8)

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Vehicle structure has slight corrosion (6.1.B.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear fog lamp not working (1.3.2b)

Offside Front Lower Seat belt anchorage prescribed area is fractured (5.2.6) DANGEROUS

Nearside Rear Trailing arm has slight play in a pin bearing (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Side repeater not working (1.4.A.2c)

Offside Front Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Trailing arm has slight play in a pin bearing (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Centre Exhaust mounting missing (7.1.1b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

welding that has been done covered in underseal cant see condition of welding

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front brake disc slightly pitted (3.5.1h)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front brake disc slightly pitted (3.5.1h)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

weling that has been done covered in underseal cant see condition of welding

Centre Front Upper Exhaust has a major leak of exhaust gases (7.1.2)

Centre Rear Upper Exhaust system not adequately supported (7.1.1)

Horn not a constant note (1.7.1e)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Front Lower Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Outer Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Brake cable locking device insecure (3.5.1l)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm severely distorted (2.4.G.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Outer Front Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Front Lower Vehicle structure is damaged, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Outer Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Brake cable locking device insecure (3.5.1l)

Offside Rear Lower Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Shock absorber has negligible damping effect (2.7.5)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

o/s top engine mounts bushes have exsessive play o/s n/s full beams inop