2008 Toyota Aygo

Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Front Service brake excessively fluctuating (1.2.1 (e))

Offside Front Service brake excessively fluctuating (1.2.1 (e))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front Sub-frame fractured holed (5.3.3 (b) (ii)) DANGEROUS

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush deteriorated (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear Bush deteriorated (5.3.4 (a) (i))

Rear Exhaust has a minor leak of exhaust gases At hanger on silencer (6.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush deteriorated (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear Bush deteriorated (5.3.4 (a) (i))

Rear Exhaust has a minor leak of exhaust gases At hanger on silencer (6.1.2 (a))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Body component corroded and likely to cause injury nearside rear wheel arch has sharp edges (6.2.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases rear joint (6.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength offside and nearside rear undersills (5.3.6 (a) (i))

Tyre slightly damaged/cracking or perishing front & rear inner sidewalls (5.2.3 (d) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Registration plate lamp not working (1.1.C.1d)