1993 Fiat Ducato

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Lower Engine mounting damaged but not to excess gearbox mounting rear bush heavily perished (6.1.8 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced underside, withstood CAT (6.1.1 (c) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

holed at both front outriggers

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

holed at both front outriggers

Brake pedal not releasing correctly and functionality of brakes affected pedal travel very low feels spongy (1.1.2 (b) (ii))

Headlamp aim so that beam "kick up" is not visible on the screen beam kick up wrong way (4.1.2 (a))

Headlamp insecure both sides at bottom (4.1.1 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides on inner faces (1.1.14 (a) (ii))

Front Coil spring corroded both sides (5.3.1 (b) (i))

Nearside Front chassis outrigger corroded and holed close to jacking point non prescribed area

Offside Front inner step at rear corroded non prescribed area

Rear Wheel bearing has slight play both sides (5.1.3 (a) (i))

Rear both sides bump stop assist bars corroded

battery light stays on alt belt very noisy

Front Bumper damaged and likely to cause injury when grazed or contacted badly corroded sharp edges (6.1.4 (a) (i))

Headlamp insecure both lamps loose at bottom (4.1.1 (c))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Bumper insecure corner bumper hanging loose (6.1.4 (a) (i))

Offside Headlamp aim too low and too far to the right. kick up in wrong direction (4.1.2 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Windscreen wiper does not clear the windscreen effectively both blades poor condition (3.4 (b) (ii))

Offside Rear Tyre has ply or cords exposed at badly cracked outer sidewall (5.2.3 (d) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Coil spring corroded both sides (5.3.1 (b) (i))

Front both sides wheels corroded

Nearside Front chassis outrigger corroded and holed non prescribed area

Offside Front exhaust mt rubber missing

Offside Rear corner of moulding on body slightly damaged

Rear Suspension component corroded but not seriously weakened both sides axle bump stop assists (5.3.3 (b) (i))

alt drive belt noisy

clutch pedal anti slip pad missing

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Brake load sensing valve seized (3.6.E.3)

Headlamp switch faulty (1.7.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

water level lamp illuminated

Access panel cannot be secured in the closed position (6.4.1)

Battery insecure (1.9.1)

Exhaust system not adequately supported (7.1.1)

Headlamp does not operate immediately when selected on dipped beam (1.7.4a)

Headlamp does not operate immediately when selected on main beam (1.7.4a)

Rear fog lamp not working (1.3.2b)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

water level lamp illuminated

1 exhaust rubber missing

Nearside Rear wheel bearing has slight play (2.6.2)

Tyre worn close to the legal limit (4.1.E.1)

battery insecure

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front brake discs rusty

Nearside Rear Service brake indicates brake bind (3.7.D.2a)

Offside Rear Rear wheel bearing has excessive play (2.6.2)

Offside Rear Service brake indicates brake bind (3.7.D.2a)

Rear fog lamp not working (1.3.2b)

front brake discs rusty

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear wheel bearing has slight play (2.6.2)

Slight leak of grease from nearside outer cv boot

Body has a sharp edge caused by damage (6.1.C.1)

Exhaust mounting missing (7.1.1b)

Front Exhaust has part of the system excessively deteriorated (7.1.1a)

Headlamp aim beam image kick up to the offside (1.8)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.5c)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear wheel bearing has slight play (2.6.2)

nearside outer cv boot slightly leaking grease but no split found

unable to fully check servo/master clyinder + bulkhead due to spare wheel

Rear Shock absorber has an excessively worn bush (2.7.4)