1993 Rover 416

Emissions not tested due to condition of exhaust system (8.2.1.2 (d))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch and sill (5.3.6 (a) (i))

Nearside Side repeater missing (4.4.1 (a) (ii))

Offside Front Body component corroded and likely to cause injury wing (6.2.1 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust system insecure (6.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Side repeater insecure (4.4.1 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust noisy (8.1.1 (a))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Rear Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)