2013 Peugeot 208

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake lever has insufficient reserve travel (1.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Exhaust has a major leak of exhaust gases clamp (6.1.2 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Inner Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Coolant leak ()

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt outer boot (6.1.7 (g) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Coolant leak ()

both front tyres worn on the outside

oil level very low

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

bracket at front of rear silencer broken