1993 Ford Mondeo

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside front tyre wearing on outer edge

Oil on engine caused by filler cap being left off,

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

nearside rear tyre sidewalls in poor condition,no cords exposed yet

Brake pipe excessively corroded (3.6.B.2c)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Direction indicator adversely affected by the operation of another lamp (1.4.A.2h)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

rear brake application uneven (3.7.B.2)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside front tyre wearing on outer edge

Oil on engine caused by filler cap being left off,

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

nearside rear tyre sidewalls in poor condition,no cords exposed yet

Both brake pipes that run alongside petrol tank starting to corrode

Nearside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

rear brake application uneven (3.7.B.2)

Both brake pipes that run alongside petrol tank starting to corrode

Nearside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Brake pipe slightly corroded (3.6.B.2c)

Exhaust system not adequately supported (7.1.1)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

rear brake application uneven (3.7.B.2)

Offside Brake pipe slightly corroded (3.6.B.2c)

Front Body has a sharp edge caused by damage (6.1.C.1)

Offside Rear Lower Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Registration plate lamp not working (1.1.5c)

nearside front lower suspension arn mounting blots fitted incorrectly causing minor damage to gearbox housing.

there is a 19% inbalance on the rear service brakes when applied together.

oil leak

Nearside Headlamp damaged but light output not reduced (1.7.5a)