1992 Rover Mini

Front Windscreen washer not working (3.5 (a))

Nearside Front Sub-frame attachment bracket/mounting insecure (5.3.3 (a) (i))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Sub-frame attachment bracket/mounting insecure (5.3.3 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Windscreen damaged but not adversely affecting driver's view chipped (3.2 (a) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Front passenger door cannot be opened from inside the vehicle (6.2.3 (a))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp insecure (4.1.1 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Exhaust system insecure (6.1.2 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Parking (secondary brake) on a single line braking system has no recorded effort at a wheel (1.3.1 (a) (ii)) DANGEROUS

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake pipe corroded, covered in grease or other material front to back covered in underseal (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

engine mounting bolt loose

heater pipe rubbing on n/s front wheel

o/s rear wheel rim damaged

rear seats not fitted at time of test

Horn not working (7.7 (a) (ii))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Position lamp not working (4.2.1 (a))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Wheel/tyre protruding beyond wheel arch ()

Nearside Rear Wheel/tyre protruding beyond wheel arch ()

Offside Front Wheel/tyre protruding beyond wheel arch ()

Offside Rear Rear reflector insecure (4.8.1 (b) (i))

Offside Rear Wheel/tyre protruding beyond wheel arch ()

large bore exhuast fitted but not excessively noisey

o/s n/s undersills showing signs of corrosion

Nearside Lower Front suspension has slight play in a lower suspension ball joint very slight play (2.5.B.1a)

Offside Front Lower Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement pear drop mounting behind front valance (2.4.G.2)

Offside Rear wheel bearing has slight play also dry sounding but not rough (2.6.2)

Vehicle structure has slight corrosion front & rear offside & nearside floor pan, sill jacking point arears (6.1.A.1)

Driver's seat cannot be secured in the upright position. (6.2.A.2)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Front passenger seat cannot be secured in the upright position. (6.2.4)

Nearside Headlamp aim too high (1.8)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Steering rack gaiter insecure (2.2.D.2d)

Nearside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)