1993 Rover Mini

Nearside Front Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Horn not working (7.7 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Side repeater not working (4.4.1 (a) (ii))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Side repeater incorrect colour (4.4.3 (a))

Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Electrical wiring insecure under dash (1.9.2a)

Horn not working (1.6.2a)

Nearside Front Shock absorber has an excessively worn bush (2.7.4)

Nearside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Inner Seat belt anchorage prescribed area is excessively corroded sill and floor (5.2.6)

Nearside Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively blade split (8.2.2)

Offside Brake pivot has restricted free movement (3.5.1k)

Offside Front Shock absorber has an excessively worn bush (2.7.4)

Offside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Headlamp aim too low (1.8)

Offside Inner Seat belt anchorage prescribed area is excessively corroded sill and floor (5.2.6)

Offside Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Seat belt anchorage prescribed area is excessively corroded seat mounting (5.2.6)

Offside Suspension component mounting prescribed area is excessively corroded door step (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively blade split (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Rear Subframe mounting prescribed area is excessively corroded front mounting (2.4.A.3)

Rear Subframe mounting prescribed area is excessively corroded offside rear front and rear mountings (2.4.A.3)

Service brake: efficiency below requirements (3.7.B.7)

Front offside and nearside brake discs pitted with corrosion

fuel pipe and filter corroded

Battery insecure

Shock absorber has a slightly worn bush (2.7.4)

both front tyres low and cracking

front brake discs corroded slightly

fuel filter pipes rusty

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Front Headlamp aim too low (1.8)

Front Steering rack gaiter split (2.2.D.2d)

Front registration plate missing (6.3.1a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Lower Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Rear Sub-frame attachment bracket/mounting bolt missing (2.4.G.1)

Offside Rear Tyre(s) incorrect because tyres with different aspect ratios are fitted on the same axle. (4.1.A.1a)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Rear fog lamp not working (1.3.2b)

battery insecure

both front lower damper bushes perished

both front tyres perrished&low o/s

front brake discs rusty

fuel filter metal pipe rusty

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Tie bar/rod severely distorted (2.4.G.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Tie bar/rod severely distorted (2.4.G.1)

front discs pitted & os slightly warped

nsr tyre

osf tyre

Nearside Front Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Upper Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Upper Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Offside rear brake binding (3.7.B.1)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)