1993 Toyota Surf

Centre Brake pipe slightly corroded (3.6.B.2c)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Centre Brake pipe slightly corroded (3.6.B.2c)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Brake fluid warning lamp illuminated (3.6.G.2)

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Brake pedal creeps down when held under pressure (3.3.B.1a)

Front registration plate missing (6.3.1a)

Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Headlamp aim too low (1.8)

Offside Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Wheel bolt(s) missing (4.2.A.1e)

Offside Headlamp aim too low (1.8)

Offside Side repeater not working (1.4.A.2c)

Rear fog lamp not working (1.3.2b)

Rear Brake pipe slightly corroded (3.6.B.2c)

shock absorbers have reduced damping effect

rear prop shaft rear joint worn.

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high (1.8)

Offside Rear Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Offside front brake binding (3.7.B.1)

Rear fog lamp missing (1.3.2a)

Registration plate lamp not working (1.1.C.1d)

rear prop shaft rear joint worn.

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Rear fog lamp missing (1.3.2a)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Propshaft component defective

slight play in rear propshaft joint

Offside Front Tyre worn close to the legal limit (4.1.E.1)

oil leak

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Steering pivot point has excessive play (2.2.B.1g)

Offside Anti-roll bar attachment bracket/mounting fractured (2.4.G.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear fog lamp insecure (1.3.2a)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear fog lamp insecure (1.3.2a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)