1992 Rover Mini

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Engine mounting damaged or deteriorated resulting in excessive movement (6.1.8 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm ball joint dust cover missing (5.3.4 (b) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Position lamp not working (4.2.1 (a))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Front position lamp(s) not working andrear (1.1.A.3b)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Registration plate lamp not working (1.1.C.1d)

rear brake application uneven (3.7.B.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside engine mounting deteriorated resulting in excessive movement (6.1.D.1a)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen wiper not operating automatically when switched on (8.2.1b)

Horn not working (1.6.2a)

Indicator tell tale missing (1.4.A.2a)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Front Side repeater not working (1.4.A.2c)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Headlamp not working on main beam (1.7.5a)

slight play in o/s top swiwel

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

slight play in o/s top swiwel

front brake discs corroded

o/s washer weak

slight pla in o/s/f hub

Offside Steering rack gaiter split (2.2.D.2d)

Registration plate lamp not working (1.1.C.1d)

front brake discs corroded

o/s washer weak

slight pla in o/s/f hub

Brake master cylinder fluid level below minimum level (3.6.G.1e)

Brake master cylinder insecurely mounted (3.6.G.1a)

Direction indicators not working (1.4.A.2c)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Exhaust system not adequately supported (7.1.1)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Headlamp aim too low (1.8)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Steering rack gaiter split (2.2.D.2d)

Nearside Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Headlamp aim too low (1.8)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear fog lamp missing (1.3.2a)

Parking brake: efficiency below requirements (3.7.B.7)

Steering column top bearing excessively worn (2.1.2c)

rear brake application uneven (3.7.B.2)

engine steady bar bushes worn to excess

fan belt missing

play in o/s/f wheel bearings

Nearside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Horn not working (1.6.2a)

Indicator switch insecure (1.4.A.1)

Nearside Front Sub-frame rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front brake disc excessively pitted (3.5.1h)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside rear brake grabbing severely (3.7.A.5b)

Offside Front brake disc excessively pitted (3.5.1h)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Nearside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Horn not working (1.6.2a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

corrosion to rear subframe, outer sills, front brake discs. nearside front sub frame mount splitting. offside front tyre perished & worn on outer edge. nearside front tyre worn on outer edge. offside r4ear tyre perished

Exhaust engine idle speed too high (7.3.A.2a)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

corrosion to rear subframe, outer sills, front brake discs. Nearside front sub frame mount splitting. Offside front tyre perished & worn on outer edge. Nearside front tyre worn on outer edge. Offside rear tyre perished.