1992 Mazda MX-5

Offside Rear Brake pipe corroded, covered in grease or other material across axle (1.1.11 (c))

Offside Rear Outer Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill as marked (7.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced under sill as marked (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Speedometer clearly inoperative (7.8 (b) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Offside Rear Brake pipe corroded, covered in grease or other material across axle (1.1.11 (c))

Offside Rear Outer Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Exhaust mounting defective (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner and outer sill and floor (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner and outer sill and floor (5.3.6 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor and inner sill (5.3.6 (a) (i))

Tyre slightly damaged/cracking or perishing Both Front (5.2.3 (d) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

o/s/track rod end grease boot cracking

poor head light patterns

rear brake effiency could be better and rear brakes binding

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

o/s/track rod end grease boot cracking

poor head light patterns

rear brake effiency could be better and rear brakes binding

Central Brake light not working

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

driver side front brake is bin ding slightly

Nearside Rear brake caliper leaking (3.6.A.1)

Offside Rear fog lamp does not emit a steady red light (1.3.2e)

front brake application uneven (3.7.B.2)

Nearside rear brake juddering slightly (3.7.A.5b)