1992 Rover Metro

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Inner sill within 30mm of seat belt mounting (7.1.1 (a) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Offside rear wheel arch within 30cm of subframe mounting / seatbelt mounting (6.1.1 (c) (i))

Oil leak, but not excessive Engine (8.4.1 (a) (i))

Oil leak, but not excessive Gearbox (8.4.1 (a) (i))

Nearside Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill corroded hole (6.2.2 (d) (i))

Nearside Rear Outer Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security nsr outer sill corroded (6.2.2 (d) (i))

Nearside Floor excessively deteriorated ROTTED THROUGH FLOOR TO SILL AND SILL (6.2.4 (a) (i))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre slightly damaged/cracking or perishing BADLY PERISHED (5.2.3 (d) (ii))

Brake lever has insufficient reserve travel (1.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Suspension arm pin or bush excessively worn trailing arm bush (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Radius arm bearing (5.3.4 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Under vehicle structure corroded

Front Upper Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)