1993 Rover Mini

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

front panel covered in underseal

Front Exhaust emissions likely to be affected by an exhaust leak pipe at manifold (8.2.1.1 (b))

Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength panel (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Central exhaust bracket broken

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Central Exhaust system insecure (6.1.2 (a))

Exhaust fumes entering cabin (6.1.2 (b) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Subframe mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Windscreen washer not working (3.5 (a))

Coolant leak ()

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Subframe mounting repair covered in underseal (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive floor area (5.3.6 (a) (i))

Offside Rear Subframe mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength floor/sill/inner wheelarch (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength floor/sill (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength floor/sill/inner wheelarch (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle 100% (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

o/s outer sill corroded and holed along edge of door opening

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

front panel is corroding

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

front panel is corroding