1992 Volkswagen Golf

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Fuel system component leaking (7.2.3)

Nearside Headlamp aim beam image kick up to the offside (1.8)

Nearside Rear wheel bearing has excessive play (2.6.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp incorrect colour (1.7.5b)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Rear wheel bearing has excessive play (2.6.2)

Offside Rear wheel bearing rough when rotated (2.6.1)

Offside Steering rack gaiter insecure (2.2.D.2d)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear brake disc excessively pitted (3.5.1h)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Rear Road wheel slightly damaged (4.2.A.1a)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Oil leak

body damage to o/s/f wing and light surround

boot can only be opened from inside

damage to both front floor panels

damage to both sill panels

n/s/r tyre low on pressure

outer sills coverd by pkastic trim

rust forming on both rear brake flexi hose ferrals

rust forming on fuel tank straps

rust forming on n/s/r floor pan

rust forming on rear axle

some wear to rear axle rubber mount no excessive movement

vehicle has been lowered

weld repair to o/s inner sill

welding repairs to o/s/f chassis rail

Anti-lock braking system warning lamp does not illuminate (3.4.1b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Headlamp aim beam image kick up to the offside (1.8)

Nearside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Nearside Rear Rear wheel bearing has excessive play (2.6.2)

Nearside Rear Road wheel bead rim badly distorted (4.2.A.1a)

Nearside Rear Sub-frame rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre incorrectly seated on the wheel rim (4.1.D.1d)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Headlamp aim too high and too far to the right. (1.8)

Offside Headlamp insecure (1.7.3)

Offside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Rear Sub-frame rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear brake disc excessively pitted (3.5.1h)

Offside Rear wheel bearing has excessive play (2.6.2)

Offside Rear wheel bearing rough when rotated (2.6.1)

Offside Steering rack gaiter insecure (2.2.D.2d)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pipe excessively corroded (3.6.B.2c)

rear brake application uneven (3.7.B.2)

brake fluid getting low

damage to o/s/f chassis leg (been repaired by welding)

front brake pads wearing low

gear selector insecure

rear axle beam starting to corrode

rear outer sills starting to corrode(behind plastic skirts)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Front Headlamp insecure (1.7.3)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear Rear fog lamp not working (1.3.2b)

Rear Registration plate lamp not working (1.1.5c)