1993 Rover 220

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Front Shock absorber has a slightly reduced damping effect (2.7.5)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Tyre fouling a part of the vehicle (4.1.D.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Cat not fitted

Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Rear tyres wearing on inner edges

Shock absorber has a slightly reduced damping effect (2.7.5)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

advanc travel to parking brake could be improved

full body kit fitted at time of test

Front Exhaust has a part missing (7.1.1a)

Front Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Front Wheel nut(s) missing (4.2.A.1e)

Front registration plate character(s) incorrectly spaced (6.3.4a)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear Wheel nut(s) missing (4.2.A.1e)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

fall body kit fitted to vehicl time of test