1993 Mercedes-benz Sprinter

Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Brake master cylinder/servo mounting prescribed area is excessively corroded (3.6.C.3)

Brakes imbalanced across an axle (3.7.B.5b)

Driver's door cannot be opened from inside the vehicle (6.2.B.1b)

Exhaust has a major leak of exhaust gases (7.1.2)

Front passenger seat insecure (6.2.3)

Nearside Axle king pin has excessive play in pin and/or bush adversely affecting the steering (2.5.A.3a)

Nearside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Front Stub axle has excessive vertical movement between stub axle and axle beam (2.5.A.1a)

Offside Headlamp aim too high (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake binding (3.7.B.1)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Drag link end ball joint has excessive play (2.2.B.1f)

Rear Drag link end seriously misaligned (2.2.C.1b)

Registration plate lamp not fitted (1.1.C.1b)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

rear brake application uneven (3.7.B.2)

Brake pad(s) wearing thin (3.5.1g)

Brake pipe slightly corroded (3.6.B.2c)

all front and rear spring bushes in poor condition

baulk head and chassis rails rusty

brake disc slightly pitted (3.5.1h)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

hand brake cables in very poor condition!!

rear brake valve linkage worn!