1993 Nissan Sunny

Fuel Pipe/s corroded ()

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust mounting defective (6.1.2 (a))

exhaust and suspension modifed

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Fuel Pipe/s corroded ()

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust mounting defective (6.1.2 (a))

exhaust and suspension modifed

Central Fuel Pipe/s corroded ()

Nearside Rear Brake pipe corroded, covered in grease or other material central, corroded (1.1.11 (c))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Brake pipe corroded, covered in grease or other material central corroded (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

modifed suspension and exhaust

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength qtr (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch near sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength qtr (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Central Rear Fuel Pipe/s corroded ()

Nearside Rear Brake pipe corroded, covered in grease or other material central corroded (1.1.11 (c))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Brake pipe corroded, covered in grease or other material central corroded (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

modifed suspension and exhaust

Rear Body getting thin underside.

Rear Brake pipe corroded, covered in grease or other material Both rear pipes. (1.1.11 (c))

Rear Metal fuel filler pipes corroded.

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Service brake excessively binding (1.2.1 (f))

Rear Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Parking brake lever ratchet mechanism worn to the extent that the brake may inadvertently release Slipping on full extension. (1.1.6 (b) (ii))

Rear Body getting thin underside.

Rear Brake pipe corroded, covered in grease or other material Both rear pipes. (1.1.11 (c))

Rear Metal fuel filler pipes corroded.

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Brake pipe corroded, covered in grease or other material n/s to o/s (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear fuel pipe corroded

front flexi hoses not located in holders

modified exhaust and suspension fitted

surface rust underside

Emissions unable to be completed system incomplete (8.2.1.2 (d))

Exhaust system insecure (6.1.2 (a))

Rear Service brake lagging in operation (1.2.1 (d))

Service brake efficiency below requirements (1.2.2 (a) (i))

Exhaust silencer likely to become detached (8.1.1 (b) (ii)) DANGEROUS

Front Exhaust shield missing where fitted as original equipment creating a risk of fire (6.1.3 (e)) DANGEROUS

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Brake pipe corroded, covered in grease or other material n/s to o/s (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear fuel pipe corroded

front flexi hoses not located in holders

modified exhaust and suspension fitted

surface rust underside

underside gearstick stabilizer arm one bolt missing

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Brake pipe excessively corroded front to rear (1.1.11 (c))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Passenger's seat insecure (6.2.6 (a) (ii)) DANGEROUS

Nearside Rear Tyre has ply or cords exposed outer side wall (5.2.3 (d) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front brake flexy hoses not located in holders ( both )

Front track rod ends no locking devices fitted ( both )

Nearside Front Electrical wiring insecure front fog light (4.11 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Rear Brake hose slightly twisted (1.1.12 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Fuel Pipe/s corroded ()

exhaust heat shield loose

vehicle has general surface rust underneath

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Bumper insecure (6.1.4 (a) (i))

Nearside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch areas (5.3.6 (a) (i))

Offside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Driver's door hinge deteriorated but the door can still be readily opened and closed (6.2.3 (c) (i))

Different Size Tyres Fitted Front To Rear

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Sill Inner & Outer (5.3.6 (a) (i))

Rear Exhaust Box Heavily Deteriorated

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Different Size Tyres Fitted Front To Rear

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Sill Inner & Outer (5.3.6 (a) (i))

Rear Exhaust Box Heavily Deteriorated

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner & Outer Sill (2.4.A.3)

Rear Exhaust Box Deteriorated

Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner & Outer Sill (2.4.A.3)

Rear Exhaust Box Deteriorated

Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Body Damage Offside Front

Both Rear Tyres Mishapen Inner Treadblock

Nearside Front Tyre worn close to the legal limit Smooth Inner Shoulder (4.1.E.1)

Offside Front Tyre worn close to the legal limit Smooth Inner Shoulder (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner & Outer Sill (2.4.A.3)

Both Front Tyres Have Slight Inner Shoulder Wear

Oil Pressure Switch Has Slight Leak Of Oil

Rear Exhaust Box Deteriorated

both front tyre's slightly fouling inner splash guards.

Nearside Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

o/s/r tyre has cracks on the outer sidewall

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Steering rack gaiter insecure (2.2.D.2d)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Steering rack gaiter insecure (2.2.D.2d)

o/s/r tyre has cracks on the outer sidewall

N/S/R tyre has cracks on the inner sidewall

O/S/R tyre has cracks & cuts on the inner sidewall

slight corrosion on the rear seal closing panels

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)