1992 Rover Mini

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Exhaust has a minor leak of exhaust gases Rear silencer blowing (6.1.2 (a))

Nearside Washer jet not efficient

Rear Body panel slightly loose Valance corroding off (6.2.1 (a) (i))

Central small hole in boot floor

front brake discs slightly pitted

front brake pads worn

Nearside Front Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Nearside Front Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Nearside Front Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords split between tread running circumference of tyre (4.1.D.1a)

Offside Front Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

front brake discs slightly pitted

front brake pads worn

Front Brake pad(s) wearing thin pads 70% worn (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened both discs corroded (3.5.1i)

Nearside Rear Tyre worn close to the legal limit 4mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit 3mm (4.1.E.1)

boot floor has small corroded hole not with prescribed area

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both from tyres have cuts in circumference of tread not deep enough to reach cords,where once rubbing on inner wheel arch. wheel clearance on lock checks

Battery insecure (1.9.1)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Seat belt insecurely fixed to the vehicles structure (5.2.1a)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Speedometer cannot be illuminated. (6.7.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Brake pipe inadequately supported (3.6.B.1)

Driver's seat insecure (6.2.A.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Passenger's seat insecure (6.2.A.1)

Nearside Front Tie bar/rod attachment bracket/mounting insecure (2.4.G.1)

Nearside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Tie bar/rod attachment bracket/mounting insecure (2.4.G.1)

Offside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Parking brake lever, pawl mechanism pivots or their associated mountings are insecure (3.1.4b)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

o/s/f outer sill holed and corroded - not within 12" of prescribed area

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Wheel nut(s) missing (4.2.A.1e)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

o/s/f outer sill holed and corroded - not within 12" of prescribed area

Horn not working (1.6.2a)

Nearside Front Direction indicators not working (1.4.A.2c)

Nearside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Direction indicators not working (1.4.A.2c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Steering rack gaiter split (2.2.D.2d)

Nearside Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Offside Front Direction indicators not working (1.4.A.2c)

Offside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Direction indicators not working (1.4.A.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Steering rack gaiter split (2.2.D.2d)

Offside Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Registration plate lamp not working (1.1.5c)

Windscreen washer provides insufficient washer liquid (8.2.3)

major corrosion on drivers door sill - not within prescribed areas

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)