1992 Mazda 626

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Hazard warning switch missing (1.4.B.1d)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front coil spring corroded (2.4.C.1b)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Headlamp aim too low (1.8)

Nearside Front front brake binding (3.7.B.1)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Headlamp aim too low (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Front Headlamp aim too high (1.8)

Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Rear brake disc slightly pitted (3.5.1h)