1992 Renault R21

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside parkbrake low effort

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust system insecure (6.1.2 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside parkbrake low effort

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

o/s sill to floor holed at front not in prescribed area

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front position lamp(s) incorrect colour (1.1.A.3e)

Offside Registration plate lamp not working (1.1.5c)

excessive oil leakes around engine

nearside rear tyre parishd

offside front chessi slightly croded

Front Headlamp not working on main beam (1.7.5a)

Front Horn not loud enough to be heard by another road user (1.6.2b)

Offside Front Anti-roll bar attachment bracket/mounting cracked (2.4.G.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

nearside rear tyre cracked badly

Inner Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear brake disc excessively scored (3.5.1h)

Offside Rear brake disc excessively pitted (3.5.1h)

Parking brake: efficiency below requirements (3.7.B.7)