1992 Rover 416

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Trailing arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Headlamp aim too high (1.8)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside drive shaft inner gaiter leaking grease

Parking brake needs adjusting

Possible exhaust leak at manifold area

Rust appearing at offside front wheel arch

Rust appearing at offside rear outer sill

Slight cracking at offside rear suspension main support bush

Steering rack worn

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Sub-frame corroded and seriously weakened (2.4.G.1)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

radiator in poor condition