1992 Toyota Land Cruiser

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced coil spring mounting (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust has a minor leak of exhaust gases tail pipe (6.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Exhaust has a major leak of exhaust gases pipe (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Front Brakes imbalanced across an axle 62% (1.2.1 (b) (i))

Nearside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Rear Body panel corroded and likely to cause injury quater panel (6.2.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced door post to sill (7.1.1 (a) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brake pipe excessively corroded load valve to flexy (1.1.11 (c))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both inner (5.3.4 (a) (i))

Front Suspension rod pin or bush worn but not resulting in excessive movement panrod arm (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Brake pipe slightly corroded rear brake pipe at brake limiter (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Body has slight corrosion sill section (6.1.B.2)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement D bush (2.4.G.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Body has slight corrosion floor area around chassis to body mount (6.1.B.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear registration plate delaminated but not likely to be misread (6.3.1d)

Front Panhard rod has excessive play in a pin/bush bush in rod where mounted to front axle (2.4.G.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill area by chassis to body mount (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings floor and webbing area around chassis to body mount (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill area around chassis to body mount (6.1.B.2)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement D bush (2.4.G.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Body has slight corrosion floor area around chassis to body mount (6.1.B.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear registration plate delaminated but not likely to be misread (6.3.1d)