1992 Rover Mini

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive inner arch (5.3.6 (a) (i))

both front shockabsorbers worn

both front shockabsorbers worn

Tyre worn close to the legal limit both rear (4.1.E.1)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Inner Front Upper Suspension arm ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Side repeater missing (1.4.A.2b)

Offside Inner Front Upper Suspension arm ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Side repeater missing (1.4.A.2b)

Rear fog lamp tell tale not working (1.3.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper not operating automatically when switched on (8.2.1b)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Front Headlamp aim too low (1.8)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is deliberately modified which significantly reduces the original strength (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear rear brake application uneven (3.7.B.2)

Nearside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Headlamp aim too far to the left (1.8)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside rear parking brake recording little or no effort (3.7.B.6a)

rear brake application uneven (3.7.B.2)

rear brakes release unevenly (3.7.B.4)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Child seat fitted not allowing full inspection of adult belt

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear position lamp(s) excessively damaged so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Stop lamp excessively damaged so that it is not visible from a reasonable distance (1.2.1d)

Rear fog lamp tell tale not working (1.3.1b)

Steering column top bearing slightly worn (2.1.2c)

all front swivels slight play

corrosion n/s/rear subframe mounting point

general underbody corrosion

Steering column top bearing slightly worn (2.1.2c)

all front swivels slight play

corrosion n/s/rear subframe mounting point

general underbody corrosion

front subframe blocks small splits †r/n/s floorpan corroded †rear floorpan in boot corroded

Centre Exhaust system not adequately supported (7.1.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

front subframe mounting blocks small splits †r/n/s floorpan corroded †rear floor pan in boot corroded

rear exhaust mountings small splits †slight play steering column †front susp bump stops missing †rear seats+belts not fitted to vehicle during test †slight play radius arm

Horn not working (1.6.2a)

Nearside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Rear Registration plate lamp not working (1.1.5c)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

rear seats+rear seat belts not fitted in vehicle during test †slight play steering column †rear exhaust mountings small splits †slight play radius arms

front indicators slightly faded †rear nearside radius arm slight play †rear seats +rear seat belts not fitted to vehicle at time of test †handbrake lever travel †slight play steering column †