1993 Rover Mini

Brake pipe corroded, covered in grease or other material All brake pipes (1.1.11 (c))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced Sill (6.1.1 (c) (i))

Offside Front Tyre slightly damaged/cracking or perishing 165/60x12 (5.2.3 (d) (ii))

Offside Front Tyre wheel/tyre protruding beyond wheel arch Plastic wheel arch partly missing (5.2.3 (f))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced Sill (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle has corrosion all round body. Plus underside of vehicle.

Brake pipe corroded, covered in grease or other material all pipes covered in grease (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Front Windscreen washer not working (3.5 (a))

Front Windscreen wiper not working (3.4 (a))

Horn sound not in accordance with requirements (7.7 (c))

Offside Front Driver's door cannot be opened from outside the vehicle (6.2.3 (a))

Brake pipe corroded, covered in grease or other material all pipes covered in grease (1.1.11 (c))

Offside Rear Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

stone chip in windscreen

Central Front Oil leaking excessively from engine (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Brake insecure back plate (1.1.21 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Exhaust has a major leak of exhaust gases back box (6.1.2 (a))

Nearside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Nearside Front suspension knuckle joint boot split.

Nearside steering rack boot twisted.

Offside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Front Upper Suspension component ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Nearside Front suspension knuckle joint boot split.

Nearside steering rack boot twisted.

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Coolant leak ()

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front jacking point showing signs of weakness

Offside Front jacking point showing signs of weakness

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front jacking point showing signs of weakness

Offside Front jacking point showing signs of weakness

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Headlamp aim too high and too far to the right. (1.8)

osr wheel slighty out of line no play

Nearside Front Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Outer Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Outer Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)