1993 Rover 216

Advisory on front number plate

Both inner cv boots split

Cracks in all tyres/uneven tyre wear

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front bottom ball joint boots split

exhaust corroded

Nearside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Headlamp aim too low (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear Exhaust system not adequately supported (7.1.1)

Advisory on front number plate

Both inner cv boots split

Cracks in all tyres/uneven tyre wear

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front bottom ball joint boots split

exhaust corroded

Nail in offside front tyre

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

nearside tyre side wall cut

Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nail in offside front tyre

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

nearside tyre side wall cut

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Horn not working (1.6.2a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)