1992 Suzuki TS50

Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a))

Fuel system component leaking Carb area! (6.1.3 (b) (i))

Headlamp aim too low (4.1.2 (a))

Rear Drive chain excessively loose (6.1.7 (c) (i))

Rear Stop lamp not working (4.3.1 (a) (ii))

Rear Upper Suspension component pin or bush excessively worn Top bush worn to excess ! (5.3.4 (a) (i))

Front Drive chain sprocket worn, but not excessively (6.1.7 (c) (i))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Drive chain sprocket worn, but not excessively (6.1.7 (c) (i))

Rear Drive chain worn but not considered excessive (6.1.7 (c) (i))

Rear Wheel bearing has slight play Sprocket carrier worn bearings + rubbers! (5.1.3 (a) (i))

Rear Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Lower Suspension rod pin, bush or joint worn but not resulting in excessive movement Linkage bushes on suspension has free play! (5.3.4 (a) (i))

Rear Sprocket carrier rubbers & bearing slight free play!

Steering headbearing has slight free play (2.2.2 (f) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Suspension pin, bush or joint worn but not resulting in excessive movement Bushes slightly worn! (5.3.4 (a) (i))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Suspension pin, bush or joint worn but not resulting in excessive movement Bushes slightly worn! (5.3.4 (a) (i))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear reflector missing (4.8.2 (a) (ii))

Front Front position lamp does not illuminate immediately when switched on (1.1.3a)

Front Headlamp switch faulty (1.2.4)

Front Horn not working (1.7.3a)

Rear Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Brake lever is so short and the brake cannot be readily applied (3.1.3c)

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition (7.1.2)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front wheel bearings have excessive free play (2.3.5b)

Nearside Handlebar handgrip not secure to handlebars. (2.1.1c)

Offside Handlebar handgrip not secure to handlebars. (2.1.1c)

Registration plate incorrect (6.3.1a)

Rear wheel bearings have slight free play (2.4.A.2c)