2010 Mazda Bongo

Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front lower suspension arm coroded

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear coilspring coroded

underbody coroded

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Central Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill to floor (6.1.1 (c) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill to floor (6.1.1 (c) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Suspension arm ball joint has slight play both (5.3.4 (a) (i))

Front underbody undersealed

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

slight corrosion to underside

slight oil leak

Nearside Rear Tyre worn close to legal limit/worn on edge 215/70/15 on 3mm tread depth (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement D bush (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive not quite within 30 cm (2.4.A.3)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement D bush (2.4.G.2)

Seat belt anchorage prescribed area is corroded but not considered excessive inner and outer sills (5.2.6)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement D bush (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive not quite within 30 cm (2.4.A.3)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement D bush (2.4.G.2)

Seat belt anchorage prescribed area is corroded but not considered excessive inner and outer sills (5.2.6)

Nearside Front Upper Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Upper Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Stop lamp not working (1.2.1b)

Nearside Front Upper Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Upper Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Headlamp aim too low (1.8)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Registration plate lamp not working (1.1.C.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)