2005 Mazda 6

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside headlight image deteriorated

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear inner and outer sills corroding

Rear sub frame corroding

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Mechanical brake component has restricted free movement (3.5.1k)

Offside Rear Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside front tyre cut on outer sidewall but not deep enough to reach cords at time of test

Offside front brake slightly grabbing

Offside front lower floor corroded but not within prescribed area at time of test

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Parking brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

Nearside front tyre cut on outer sidewall but not deep enough to reach cords at time of test

Offside front brake slightly grabbing

Offside front lower floor corroded but not within prescribed area at time of test

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

offside rear brake dragging slightly

Nearside Inner Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Inner Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

rear suspension and sub frame starting to corrode

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Inner Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Inner Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pad(s) wearing thin (3.5.1g)

front disc rusty times 2

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front brake disc quite worn and pitted.

Parking brake lever has no reserve travel (3.1.6b)