2000 Jaguar Xj

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b))

Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Seat belt slightly damaged (7.1.2 (b) (i))

Offside Front Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

stone chip to windscreen

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Sub-frame pin or bush excessively worn nearside and offside rear (5.3.4 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced nearside and offside rear (6.1.1 (c) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive chassis member. (5.3.6 (a) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive chassis member. (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive chassis member. (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits 1.05 (8.2.1.2 (c))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive chassis member. (5.3.6 (a) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive chassis member. (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive chassis member. (5.3.6 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced chassis member/inner wing. (6.1.1 (c) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

floor pan/suspension corroding.

Nearside Front inner wing/chassis member corroded.

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both front floor pans corroding.

rear chassis members corroded.

Nearside Front inner wing corroding

Rear subframe/suspension corroding

underbody/floorpan corroding

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Vehicle structure has slight corrosion (6.1.A.1)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

offside front floorpan corroded.

Front front brake application uneven (3.7.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear registration plate margin less than the minimum requirement (6.3.4g)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Vehicle structure has slight corrosion (6.1.A.1)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

offside front floorpan corroded.

Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

offside front tyre, outer sidewall cracked.

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

offside front tyre, outer sidewall cracked.

Offside Rear wheel bearing has slight play (2.6.2)

surface corrosion to underside.

All position lamps not working (1.1.A.3b)

Registration plate lamp not working (1.1.C.1d)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Rear brake disc slightly pitted (3.5.1h)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

offside rear driveshaft inner bearing slight play.

Rear tyres at 3 and 4mm.