2003 Toyota Yaris

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Front Windscreen damaged and affecting the driver's view of the road (3.2 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Headlamp aim too low (4.1.2 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Central Stop lamp(s) not working high level (4.3.1 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Seat belt not functioning as intended (7.1.2 (c))

Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Seat belt not functioning as intended (7.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases front and rear (6.1.2 (a))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Headlamp aim too high and too far to the right. (4.1.2 (a))

Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both beam images slightly reduced

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Rear Outer Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both beam images slightly reduced

Nearside Front Tyre tread depth below requirements of 1.6mm bald inner (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm bald inner (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Offside Rear coil spring broken (2.4.C.1a)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)