2007 Chevrolet Matiz

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Emissions unable to be completed (8.2.1.2 (d))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust system insecure (6.1.2 (a))

slight general underbody corrosion

Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Suspension component pin or bush slightly worn front top mounts (5.3.4 (a) (i))

Tyre slightly damaged/cracking or perishing all tyres - rears dated 2006 - fronts 2013 (5.2.3 (d) (ii))

general underbody corrosion

Brake pipe corroded, covered in grease or other material various (1.1.11 (c))

Exhaust has a minor leak of exhaust gases front flexi (6.1.2 (a))

vehicle has widespread surface rust.

various suspension components have surface rust

Suspension arm corroded but not seriously weakened both sides front (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Brake pad(s) incorrectly mounted friction material no longer bonded to pad backing causing brake to jam. (1.1.13 (c)) DANGEROUS

Suspension arm corroded but not seriously weakened both sides front (5.3.3 (b) (i))

Exhaust mounting defective front (6.1.2 (a))

Service brake binding but not excessively both sides front (1.2.1 (f))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Exhaust mounting defective front (6.1.2 (a))

Service brake binding but not excessively both sides front (1.2.1 (f))

fuel filter corroded

front exhaust bracket corroded off but exhaust system still secure.

fuel filter has surface corrosion

oil and fuel filters corroded

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

rear brake application uneven (3.7.B.2)

oil and fuel filters corroded

Nearside rear brake binding (3.7.B.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

nearside front tyre cracking and wearing on edges

offside front tyre worn on inner edge