2007 Chevrolet Lacetti

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded wheel arch (1.1.11 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Windscreen in such a condition that visibility through swept area is seriously affected product on glass causing lack of sufficient visibility (3.2 (c) (ii)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material wheel arch (1.1.11 (c))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Exhaust has a major leak of exhaust gases front flexi (6.1.2 (a))

Nearside Front Anti-lock braking system wheel speed sensor excessively damaged (1.6 (c))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Anti-lock braking system wheel speed sensor excessively damaged (1.6 (c))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Exhaust has a minor leak of exhaust gases (7.1.2)

brake disc worn, pitted or scored, but not seriously weakened all (3.5.1i)

exhaust deteriorated

Exhaust has a minor leak of exhaust gases (7.1.2)

brake disc worn, pitted or scored, but not seriously weakened all (3.5.1i)

exhaust deteriorated

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

brake disc worn, pitted or scored, but not seriously weakened all (3.5.1i)

exhaust deteriorated

Brake pipe slightly corroded all (3.6.B.2c)

brake disc worn, pitted or scored, but not seriously weakened both front inner edges (3.5.1i)

Brake pipe slightly corroded (3.6.B.2c)

Nail in nearside rear tyre

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

metal brake pipes starting to corrode