2001 Peugeot 206

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened both fronts (1.1.14 (a) (ii))

Front Service brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Side repeater slightly discoloured (4.4.3 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

park brake travel long

under body surface corrion

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced center (6.1.1 (c) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Nearside Front Oil leaking excessively from engine (8.4.1 (a) (i))

Nearside Front Position lamp not working side (4.2.1 (a) (ii))

Offside Front Side repeater incorrect colour (4.4.3 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Service brake effort inadequate at a wheel NSR AND OSR (1.2.1 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Fuel tank slightly loose STRAP (6.1.3 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Upper strut top bearing slightly noisy

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Nearside Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Upper strut top bearing slightly noisy

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Front Upper strut mounting slightly stiff

Rear Brake prescribed area is corroded but not considered excessive back plates (1.1.21 (e) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

corrosion to under side

Emissions not tested (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak rear silencer leaking requires from cat back (8.2.1.1 (b))

Nearside Side repeater incorrect colour (4.4.3 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Front Upper strut mounting slightly stiff

Nearside Rear Tyre worn close to legal limit/worn on edge 17/65/14/82t (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake prescribed area is corroded but not considered excessive back plates (1.1.21 (e) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

corrosion to under side

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake load sensing valve stiff (1.1.17 (c) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Brake pipe excessively corroded front to rear (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Brake load sensing valve stiff (1.1.17 (c) (i))

Nearside Brake pipe slightly corroded front to back brake pipe (3.6.B.2c)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Brake pipe slightly corroded front to back brake pipe (3.6.B.2c)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear fog lamp not working (1.3.2b)

Brake pipe excessively corroded compensator to nearside rear (3.6.B.2c)

Brake pipe excessively corroded front to rear (compensator) (3.6.B.2c)

Nearside Side repeater excessively damaged so that it is not visible from a reasonable distance (1.4.A.2e)

Nearside Side repeater not working (1.4.A.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Advisory parking brake 17% may require adjustment or repair

Advisory service brake 50% RBT may require adjustment or repair

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Registration plate lamp not working (1.1.C.1d)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Lower Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Upper Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust system not adequately supported (7.1.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Suspension joint nearside lower dust cover split/missing

Brake load sensing valve linkage seized (3.6.E.3)

Nearside Direction indicators incorrect colour (1.4.A.2f)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Rear Direction indicators incorrect colour (1.4.A.2f)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Rear Direction indicators incorrect colour (1.4.A.2f)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Suspension joint nearside lower dust cover split/missing

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Brake load sensing valve linkage seized (3.6.E.3)

n/s/r tyre 2mm

o/s/r tyre 3mm