2005 Mazda 6

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Registration plate missing (0.1 (a))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill holed and corroded (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill holed and corroded (5.3.6 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases rear joint (6.1.2 (a))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Registration plate insecure but not likely to fall off (0.1 (a))

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive Inner sill to floor pan (5.3.6 (a) (i))

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive Inner sill to floorpan (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Registration plate insecure but not likely to fall off (0.1 (a))

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive Inner sill to floor pan (5.3.6 (a) (i))

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive Inner sill to floorpan (5.3.6 (a) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Extensive underbody surface corrosion

Rear of both inner sills may need welding repairs before next test

Extensive underbody surface corrosion

Rear exhaust hanger broken but system is still adaquetely supported