2008 Chevrolet Matiz

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive wheel arch (5.3.6 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear axle corroded

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive wheel arch (5.3.6 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear axle corroded

Brake pedal pivot has excessive wear or free play (1.1.1 (b))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Child Seat fitted not allowing full inspection of adult belt

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Rear Child Seat fitted not allowing full inspection of adult belt

Child Seat fitted not allowing full inspection of adult belt

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Service brake: efficiency below requirements (3.7.B.7)

Nearside rear brake recording little or no effort (3.7.B.5a) DANGEROUS

Offside rear brake recording little or no effort (3.7.B.5a) DANGEROUS

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Rear Mechanical brake component has restricted free movement (3.5.1k)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)