2008 Iveco Daily

Front bolt on panel underside of engine corroded holed

Nearside Outline marker lamp not working x2 (4.2.1 (a) (ii))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor above spring at rear wheel (6.1.1 (c) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Outline marker lamp not working (4.2.1 (a) (ii))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Front bolt on panel holed bit not structural

Hazard warning switch faulty (4.4.2 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit inner edge (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

n/s/f marker lite inop

Headlamp aim not tested (1.8.A.1c)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Rear position lamp(s) not working (1.1.A.3b)