2001 Mercedes-benz Vito

corrosion rear brake pipes

inner sills corroding

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Anti-roll bar linkage pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Anti-roll bar linkage has slight play in a pin/bush Both rear (2.4.G.2)

Handbrake travel

Nearside Rear Brake pipe slightly corroded To Flexi (3.6.B.2c)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Seat belt anchorage prescribed area is excessively corroded inner sill (5.2.6)

Nearside Front Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Rear passenger door cannot be opened from outside the vehicle (6.2.B.1c)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded inner sill (5.2.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Offside Headlamp not working on main beam (1.7.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

steel brake pipes corroded

Glow plug fault light on

Nearside Front Body has slight corrosion jacking point (6.1.B.2)

Nearside Rear Brake slightly binding

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings jacking point (6.1.B.2)

Offside Registration plate lamp not working (1.1.C.1d)

Glow plug fault light on

Nearside Front Body has slight corrosion jacking point (6.1.B.2)

Nearside Rear Brake slightly binding

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

undertray fitted

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Headlamp aim too low (1.8)

Offside Front Headlamp aim too high (1.8)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Headlamp aim too low (1.8)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Air suspension has no suspension movement (2.4.D.5)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

osf inner c/v boot split

Nearside Front Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Nearside Rear Registration plate lamp not working (1.1.5c)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

osf inner c/v boot split

Nearside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

hole in n/s h/lamp glass

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Front Brake hose excessively damaged (3.6.B.4d)

Nearside Headlamp aim too high (1.8)

Nearside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Offside Headlamp aim too high (1.8)

hole in h/lamp glass n/s

Nearside Front Headlamp not in good working order but not adversely affecting beam image (1.2.4a)