2003 Peugeot Partner

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Exhaust has a major leak of exhaust gases box (6.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen washer not working (3.5 (a))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Brake pipe corroded, covered in grease or other material Marked in yellow chalk (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Horn not working (7.7 (a) (ii))

Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Brake pipe corroded, covered in grease or other material Marked in yellow chalk (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Front brake pads look to be wearing low.

Front subframe corroding.

Oil leak, but not excessive (8.4.1 (a) (i))

SRS light reset at time of test.

Front brake pads look to be wearing low.

Front subframe corroding.

Oil leak, but not excessive (8.4.1 (a) (i))

SRS light reset at time of test.

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Horn not working (7.7 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Brake load sensing valve inoperative and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Front brake pads look to be wearing low.

Front subframe corroding.

Nearside Headlamp aim too high (4.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Both rear tyres cracking between tread.

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside front tyre 2mm.

Offside front tyre 2.5mm.

Oil leak, but not excessive (8.4.1 (a) (i))

Spare tyre worn low on edge.

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Both rear tyres cracking between tread.

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside front tyre 2mm.

Offside front tyre 2.5mm.

Oil leak, but not excessive (8.4.1 (a) (i))

Spare tyre worn low on edge.

Nearside Side repeater not working (1.4.A.2c)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b)

Nearside Front position lamp(s) not working (1.1.A.3b) DANGEROUS

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Registration plate lamp not working (1.1.5c)