2004 Honda Hr-v

Front Engine mounting damaged but not to excess x2 (6.1.8 (a) (i))

Front Exhaust mounting defective flange weak (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced front and rear (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Position lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed (5.3.6 (a) (i))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Engine mounting damaged but not to excess x2 (6.1.8 (a) (i))

Front Exhaust mounting defective flange weak (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced front and rear (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Front Engine mounting damaged but not to excess all rubbers deteriorated (6.1.8 (a) (i))

Front Exhaust mounting defective mounting (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Exhaust system insecure centre to rear flange (6.1.2 (a))

Offside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced arch holed (7.1.1 (a) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Engine mounting damaged but not to excess all rubbers deteriorated (6.1.8 (a) (i))

Front Exhaust mounting defective mounting (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Vehicles internal headlight adjuster altered to recheck lights ()

Exhaust mounting defective Complete system mounting points very thin (6.1.2 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Wheelarch (7.1.1 (a) (i))

Exhaust mounting defective Complete system mounting points very thin (6.1.2 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Brake pipe slightly corroded both rear (3.6.B.2c)

Brake pipe slightly corroded both rear (3.6.B.2c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

o/s/f brake slightly binding

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

both rear tyres starting to perish